LATNEX HF-B8G
Isotropic tri-axis RF field-strength meter covering 10 MHz to 8 GHz over 38 mV/m to 20 V/m, with per-axis display, max and average readings, a calibration certificate in the box and manual storage of 200 data sets.
Last verified 12 August 2026.
Also searched as: HF-B8G, HFB8G, LATNEX 3-axis RF meter
- Manufacturer
- LATNEX
- Model
- HF-B8G
- Type
- Broadband meter
- Instrument class
- Broadband RF power-density meter
- Quantities measured
- electric field strength, power density
- Axes
- triple
- Peak hold
- Yes
- On-device logging
- Yes
- Market status
- Currently sold
Frequency coverage by mode
One band per measuring mode, as the manufacturer states it.
- electric field strength
- 10 MHz – 8 GHz
- power density
- 10 MHz – 8 GHz, the same sensor read out as power density
Display range by mode
- RF field strength, isotropic
- 38 mV/m – 20 V/m (resolution 0.1 mV/m; 0.001 µW/m²)
Calibration
Supplied with a calibration certificate according to the manufacturer's listing, plus a user calibration factor settable from 0.10 to 9.99 — a correction factor, not a traceable calibration.
Suited to
- Isotropic RF surveys where orientation should not change the reading: all three axes are summed and each can also be read individually
- Wide low-end coverage down to 10 MHz, which takes in shortwave and FM broadcast that most consumer RF meters miss
- Recording a set of survey positions: 200 manual data sets stored on the meter
What it cannot do
- No low-frequency magnetic or electric field measurement
- Nothing above 8 GHz
- The 38 mV/m floor is around 3.8 µW/m², so it cannot resolve the very low levels precautionary sleeping-area targets are written at
- No spectrum or frequency counter, so a reading cannot be attributed to a service
- A supplied certificate is the manufacturer's own; it is not an ISO/IEC 17025 accredited calibration unless the certificate says so
What these figures are
Every number on this page is the manufacturer's own declared specification, reproduced so that models can be compared field by field. Nothing here is an independent test of the instrument, a calibration certificate, or a statement that a reading taken with it can be compared with a regulatory limit — that depends on the detector, the averaging and, where it matters legally, an accredited calibration.
Where to buy
EMR Shielding Solutions is a related company of WebKMS, which publishes EMFBase, and sells this product. The link is a stockist listing only: every figure on this page comes from the manufacturer's own documentation, and no specification, limitation or citation depends on it.
Related records
- Broadband RF power-density meter
The general-purpose instrument for Wi-Fi, cellular, 5G, smart meters and cordless phones: reports total power density across a wide band in µW/m² or mW/m², with peak-hold and average modes.
Instruments
- RF room survey
How to measure radiofrequency exposure in a room so the result is reproducible: peak and average, at body positions, with the dominant direction identified.
Measurement protocols
- Electric field strength
Volts per metre, reported both for power-frequency electric fields near wiring and for radiofrequency fields near transmitters.
Quantities & units
Sources
- latnex-hf-b8g LATNEX HF-B8G professional RF meter — specifications — LATNEX. manufacturer, link checked 2026-08-12.
Same record, other formats